By HomeSeer Manager on 05 November 2006 21:31

I finally decided to bite the bullet and go with V2 of HomeSeer as my primary automation controller. This was largely due to its maturity, stability, performance & importantly its range of plugins and support from others. Notably, James' xAP HomeSeer conduitMainLobby bridge.

HomeSeer has very good latency with respect to responding to X10 commands received via CM12 and issuing an immediate command back out on the power again. Also, combined with the HomeSeer W80032RF plugin I now find X10 device response to a RF wall switch or motion detector far more acceptable.

The only decision I have to make going forward now is whether to develop HomeSeer plugins to plug my gaps or continue developing xAPplications . I prefer the latter as once stable, I can share these with the xAP community irrespective of  whether they are using HS or not.

...

Read More »